Description
Overview
EFA-Y-BRACKET-150 is a mounting bracket accessory used to secure ELGi filter assemblies in a clean, space-saving installation. It supports wall-mount or structure-mount layouts to keep filters aligned, reduce piping stress, and improve service access.
Key Features
- Space-saving mounting for organized filter installations
- Improves stability by supporting filter bodies and reducing load on piping connections
- Service-friendly layout with better access for element changes and drain checks
- Designed for filter setups where consistent alignment and secure mounting matter
Typical Applications
- Compressor rooms and utility areas where floor space is limited
- Multi-filter trains (pre/fine/carbon) requiring clean alignment
- Retrofits where existing piping needs added support
- Point-of-use filtration stations near sensitive equipment
Installation Notes
- Mount to a structural surface using anchors/hardware rated for the load and environment.
- Maintain clearance for bowl removal and element service.
- Keep filters in the recommended orientation and route drain lines to an appropriate condensate handling system.
FAQs
What does the “150” designation refer to?
It typically indicates a size/fit category for certain filter setups. Confirm the correct bracket by matching your filter model/size and installation layout requirements.
Is this required to install ELGi filters?
Not always, but a dedicated bracket is strongly recommended for wall-mounted installations or where piping alone should not support the filter weight.
Can I mount multiple filters together?
Yes—multi-filter trains often use a combination of mounting hardware and connection accessories to keep filters aligned and supported. Use enough brackets to support the total assembly weight.
What should I verify before ordering?
Confirm your filter model, connection size, and whether your installation is single-filter or a multi-filter train so the bracket matches the intended configuration.
