Description
ELGi EOS Oil/Water Separator, EOS - 13 — B070007000002
ELGi EOS oil/water separators are designed to treat lubricated compressor condensate before it is discharged. The multi-stage separation media helps reduce oil content in the condensate to support environmentally responsible disposal.
The EOS design uses a layered treatment process with fiber adsorbent and activated carbon to capture oil and contaminants while allowing water to pass through.
Key Features
- Effluent treatment support: Designed to help achieve <10 ppm oil content in treated condensate (confirm local discharge requirements).
- Right-sized capacity: EOS - 13 is rated for compressor systems up to 130 SCFM.
- Oil adsorption capacity: Up to 0.8 gal of oil adsorption capacity (helps estimate service intervals).
- Multi-stage media: Fiber adsorbent + activated carbon for reliable oil capture.
- Simple hose connections: Barbed inlet/outlet connections for condensate routing (inlet 0.4" ID, outlet 0.5" ID).
- Maintenance-ready: Service kits are available for different compressor oil types.
Specifications
| Model | EOS - 13 |
|---|---|
| MPN | B070007000002 |
| Rated Compressor Capacity | 130 SCFM |
| Max Oil Adsorption Capacity | 0.8 gal |
| Hose Barb (Inner Dia.) | Inlet 0.4" / Outlet 0.5" |
| Package Dimensions (L × B × H) | 15.6" × 9.5" × 15.2" |
| Gross Weight (Empty) | 13 lb |
Service & Maintenance
- Standard service kit: B070007000008A
- PG oil service kit: B070007000025A
- Special oil service kit: B070007000024A
- Replace media as needed: Actual change intervals depend on condensate volume, oil type, and operating hours.
Installation & Maintenance Tips
- Route all condensate drains: Feed condensate from compressor, aftercooler, receiver, dryers, and filters into the separator (as applicable).
- Plan for larger systems: For multi-compressor rooms, use multiple separators and a condensate distributor to split flow evenly.
- Keep it accessible: Install where media/service kits can be replaced without disrupting production.
FAQs
▶️ Question: How do I size an EOS separator—why is EOS - 13 rated at 130 SCFM?
Answer: The rating is a sizing reference for total connected compressor capacity. Choose a model that meets or exceeds your system SCFM. If your installation has multiple compressors or high condensate volume, consider stepping up a size or using multiple EOS units with a distributor.
▶️ Question: What does “<10 ppm” mean for treated condensate?
Answer: It refers to the targeted oil content after treatment. Local discharge limits vary, so use this as a performance reference and verify your site’s compliance requirements.
▶️ Question: What does the 0.8 gallon oil adsorption capacity tell me?
Answer: It indicates how much oil the media can adsorb before replacement is typically required. Actual life depends on oil type, condensate load, and operating conditions.
▶️ Question: Which service kit should I use?
Answer: Use the standard kit for typical lubricated compressor oils. If your compressor uses PG (polyglycol) oil, use the PG kit. For other specialty oils, use the special oil kit. For this model: Standard B070007000008A, PG B070007000025A, Special B070007000024A.
▶️ Question: Where should an oil/water separator be installed in the system?
Answer: Install it downstream of condensate collection points so all drains can feed into it before discharge. Keep the unit level, provide proper tubing/hoses to the inlet/outlet, and ensure safe access for service.
